Search results

The plastic shaft on the lead treble pot of my Mark IV short head sheared off. I tried gluing the shaft back together, but it didn't last. Has anyone tried to replace the pot and, if so, how difficult was it, both the get to the part and then to put the new part in? Will Mesa sell an end-user...

I'll be gigging for the first time with my new TA-15 this weekend: Saturday, January 15, 2011 (9:00 pm until closing) Brothers Encore 5135 Waterway Drive, Dumfries, VA 22025 phone: 703.680.0032 brothersencore.com/ Since the TA-15 has no reverb circuit, also making its debut appearance will be...

I have a TA-15 on order from Sweetwater, which I would like to use with one or both 8 ohm 1-12" cabs (one open back EVM, and one Thiele) that I currently use with my Mark IV. The on-line manual pictures a range of generic speaker connection options, but not the connection of two 8 ohm cabs to...

I'm thinking of replacing my short head Mark IV with a Mk V. It looks like the Compact Widebody is the lightest Mesa 1 X 12 that might match up, at 33 lbs and 22.5" wide, while the Mk V head is 22.75" wide. I'm guessing that a 1/8" overhang of the head on either side of that cab isn't enough...

Clean and crunch on my Mk IV are fine; didn't change any settings, but my lead channel recently began to feed back immediately upon switching to it. I used the on-board spare pre-amp tube (12AX7), swapping it for V1, V2, and V3 without any improvement. V4 is a 12AT7 ECC81, and the earlier...