mboogman
Active member
- Joined
- Nov 3, 2011
- Messages
- 33
- Reaction score
- 0
Posted this in the announcements section, but I figure it should be in here too, since, it's about a rack piece, so here ya go.
I just got done doing a little work on my Mesa Studio Preamp. When I bought it, the reverb tank was not working, so I replaced it with a tank from MojoTone. Sounds great! While I was at it, I went ahead and set it up for the MKIIc+ tone stack. I think it made a huge difference in the overall feel of the lead channel.
Here's a quick recording I did one morning before heading off to work.
http://soundclick.com/share.cfm?id=11184795
I normally would have an SM57 on the cabinet, but all I had on hand at the time was one of my AT4040's. No FX, just straight into the preamp, then into my VHT 2:Ninety:2 power amp, into my Peavey JSX cab, which is less than ideal, but you'll get the idea.
I just got done doing a little work on my Mesa Studio Preamp. When I bought it, the reverb tank was not working, so I replaced it with a tank from MojoTone. Sounds great! While I was at it, I went ahead and set it up for the MKIIc+ tone stack. I think it made a huge difference in the overall feel of the lead channel.
Here's a quick recording I did one morning before heading off to work.
http://soundclick.com/share.cfm?id=11184795
I normally would have an SM57 on the cabinet, but all I had on hand at the time was one of my AT4040's. No FX, just straight into the preamp, then into my VHT 2:Ninety:2 power amp, into my Peavey JSX cab, which is less than ideal, but you'll get the idea.