McBarry
Well-known member
Hi folks,
first up, HAPPY NEW YEAR !!
After successfully procrastinating and then letting life get in the way, I've finally finished the CAD schematic for my Mk IIB 100 simul/export/rev/GEQ.
Last night I put it in the wrong section, but now it's in the Mark Series for all the "true believers"...hahaha
Now I don't profess it's absolutely error-free, but it's prett **** close.
All the voltages are specific to this chassis - yours may vary considerably.
There's still some tidying up to do, but it's essentially all there.
I used TINYCAD and so you ned to D/L that prog to open the file, unless U have another sneaky way..
I'll investigate saving it as a pdf so it's easier to open, but it's 1am here and I'm buggered...
Hope it's of use and Happy New Year from Down Under !!
Dave
http://www.mediafire.com/?gftsqdb9ctq8dy4
first up, HAPPY NEW YEAR !!
After successfully procrastinating and then letting life get in the way, I've finally finished the CAD schematic for my Mk IIB 100 simul/export/rev/GEQ.
Last night I put it in the wrong section, but now it's in the Mark Series for all the "true believers"...hahaha
Now I don't profess it's absolutely error-free, but it's prett **** close.
All the voltages are specific to this chassis - yours may vary considerably.
There's still some tidying up to do, but it's essentially all there.
I used TINYCAD and so you ned to D/L that prog to open the file, unless U have another sneaky way..
I'll investigate saving it as a pdf so it's easier to open, but it's 1am here and I'm buggered...
Hope it's of use and Happy New Year from Down Under !!
Dave
http://www.mediafire.com/?gftsqdb9ctq8dy4
