Recent content by TSM

Hi, What kind of footswitch is that? I see "boost" sign on it. Ho do you get your signal boosted with footswitch?

Basically, it's the same thing...as long as you can switch between two channels using one relay.

Hi Greg, First, make sure you set the rotary switch on the back of the amp to FT SW (you don't need to have your footswitch connected). This will automatically put your amp in state where you have a Lead channel (with EQ on) as a default one. Now you can use a relay from your Line 6 (I use a...

My girls :)

Here is a couple of pictures from the recording session:

This song is completely recorded with 50Cal+: https://www.youtube.com/watch?v=-vVFzW9YJt4 Guitar solo and one take of the guitar on this one I also recorded with 50Cal+: https://www.youtube.com/watch?v=NBb9bpXTCN4

Hi guys, I've recently converted my Mark IV from combo to head but I left it without reverb and fan. Is it safe to run amp without cooling fan?

Same situation here. It's very hard to be a musician. Usually you need a day job and music is just an expensive hobby :)

Thanks! The lyrics are in Serbian :)

These two song are completely recorded with Mesa Boogie Caliber 50+...check it out: http://www.youtube.com/watch?v=-vVFzW9YJt4 http://www.youtube.com/watch?v=GuLUYyYLbC0

I had the same experience with 50 Cal+. Tubes can make wonders :)

If I set volume pot to value where I can get clean tone without breakup (for example arround 4-5), is it possible to add some gain to lead channel only? Can I do this with lead drive mod? In other words, does additional lead drive pot add or subtract gain from volume pot?

Your gain settings is way to high for my taste. I found that anything above 7 will bring nothing but mess in my lead tone. Riffs will also loose tightness. I set master volume to 6 and lower the overall sound level with the pot on the TC G major (between preamp out and poweramp in). This...

I bought this beauty a year ago and it was a huge improvement in my sound but I wasn't completely satisfied with the tone. It was a little bit harshy, "ice pick" sound with the lack of bottom and low middle. It seemed that my solo tone needed a little bit more gain, or sustain. I changed a lot...