Recent content by notyalcer

I am using a Critter Electronics CFR Klone (Klon clone, obviously), with the gain set low and volume and treble moderately high. This just does the right thing as a boost into the MkV90's Channel 2 or 3, seems to goose all the right frequencies without adding bass flub or midrange splat...

.

.

.

That is helpful information! Thank you. I have only owned my Mark V for a few months, got it used with 2 years left on the tanferable warranty. I have not playing this amp live yet, not gigging that much but have some gigs coming up in late summer/fall. If the amp did this routine during a...

I have very similar symptoms with my amp. Very random but probably once a week the amp will shut down and back on. I hear the fan shut off, the relays click, and then everything starts up again, all within a second or less. Occasionally it will do it again within a few seconds. It seems once the...

I swapped the C90 in my MK V with an Eminence Texas Heat. From what you described, I think you would probably really like it. It added sweetness, for lack of a better word, to the voice of the MK V. It’s a darker speaker but still has plenty of high end and a very pleasing, singing midrange. It...

I have a non-plus 5:25. Almost immediately I changed out the Mesa Vintage 30 for a Cannabis Rex, more out of reflex than anything else. Sounded very good but found that it tended to over-emphasize the lower end in a unbalanced way - too flabby - that I could not dial out. Also tried briefly a...

I learned something recently with my setup described above. The manual clearly states that the channel Master knobs set the send level for the effect send, which I had forgotten. Well, I was playing the amp at a recording session and did not use the effect loop. While dialing it in, I set the...

Those look too large for EL-84s but a great idea.

I have a Lonestar Special, but the loop circuitry is identical to your Classic. I use a Akai Headrush delay in the loop. I am using a 4 cable method, using a Hosa stereo cable to make the connection between the loop send/return and the delay in/out. This setup works very well. I personally...

YES! This drives me nuts. I have the LSS, and the wire retainers do not firmly hold the EL84s in their sockets. They tend to angle forward due to vibration or getting moved by the power cord. It doesn't seem to take much. At my third gig with this amp, I turned it on at soundcheck and it started...

I noticed a third button in the middle of your LSS footswitch. Did you by chance do the mod to make the drive pot footswitchable? Been thinking about doing this. Thanks.

Very interesting! Glad you are happier with your tone - that is such a great feeling. I have a LSS, and I've considered swapping an Eminence GB-12 into it. This is supposedly a greenback clone, and is a really nice sounding speaker. I have it in my old Studio .22 which I've been using as an...

Update: Plan-X is correct, no resistors needed.