List of filter capacitors needed for a Mark III cap job

The Boogie Board

Help Support The Boogie Board:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

jofipe

Member
Joined
Jan 31, 2011
Messages
21
Reaction score
0
Hi there. I'm gonna send my amp to the tech, but he doesn't use F&T caps (JJ only), so i'm gonna just order them online myself.

So far what i'v gathered I need:
The main filters are 4X220uf/300V. The preamp decoupling caps are 3X30uf/500V.

Anything else?

Thanks!
 
2X220uf/63v for the EQ supply and 2X80uf/75v for the bias supply.
 
Tank you very much stokes! I take it that these ones have a rather minor effect on the overall tone?
 
jofipe said:
Tank you very much stokes! I take it that these ones have a rather minor effect on the overall tone?
Yes,but they are electros and are just as old as the power filters,cost is minimal compared to the filters so while you're in there......If you cant find exact values,close is good enough for these,as long as the voltage is the same or higher.Be careful tho,physical size can be an issue,theres not a lot of room where these are located.
 
stokes said:
2X220uf/63v for the EQ supply and 2X80uf/75v for the bias supply.


Where is the EQ Supply located...I can't locate the 2 caps...please help.
Cheers, Paul
 
Back
Top