Mark V25 / Moen GEC9 channel switch noise

The Boogie Board

Help Support The Boogie Board:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Tony N

New member
Joined
May 5, 2017
Messages
1
Reaction score
0
Hi everyone,
I"m new to the forum and a new Mesa owner. I'm hoping someone here can help me with this problem, I'll do my best to describe it without writing a novel.
I have am using a Moen GEC9 loop switcher to control my pedals, change channels and turn the eq on and off. I'm using a TRS cable from the amp to the pedal board junction box (Temple Audio), from there an insert cable that splits the TRS to RS and TS. These plug into two separate loops in the switcher that contain relays, both normally closed. The RS turns the eq on and off and the TS changes channels. I have narrowed down the source of this terrible "ground noise" to the TS or the channel switch loop. I have confirmed that the cables are perfectly good and I used this switcher in a similar way with my last amp (PRS Archon) with no issues. There is no noise when using the Mesa foot switch that comes with the amp.
Any thoughts on this are greatly appreciated.
Tony N
 

Latest posts

Back
Top