Hi everybody,
My triaxis V2 has a bad, muddy sound on Lead 2 (green, yellow and red) mode. Changing the tubes didn't solved the problem.
I want to check the LDR calibration procedure, but I can't find the right LDRs on the TX1 board, I'm unable to read the inscriptions on the board.
Is there any implantation schematic (or picture) showing where are the LDRs to be checked ? Didn't found anything on the net, except the electronic schematics.
Regards
My triaxis V2 has a bad, muddy sound on Lead 2 (green, yellow and red) mode. Changing the tubes didn't solved the problem.
I want to check the LDR calibration procedure, but I can't find the right LDRs on the TX1 board, I'm unable to read the inscriptions on the board.
Is there any implantation schematic (or picture) showing where are the LDRs to be checked ? Didn't found anything on the net, except the electronic schematics.
Regards
