Lonestar Classic Head Total Loss of Sound

The Boogie Board

Help Support The Boogie Board:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Hompie29

Member
Joined
Aug 18, 2017
Messages
5
Reaction score
0
Location
Edinburgh. UK
Hi. I'm new to the forum and have a problem. Any help would be really appreciated.
Last night at practice I plugged in and switched on. The amp was on the 2nd channel an it seemed to have more hum than normal but was sounding good when I played. I switched to channel 1 with the footswitch. No hum whatsoever and it was working perfectly. I switched back to channel 2 and no sound!! Switched back to ch1 and no sound and I mean zero sound not even the sound of the amp being on. Only the fan. Switched the amp off and on a couple of times. Unplugged the footswich flicked the channel switch the wattage switches and the silicon/tube rectifier switch. Nothing!! All I could get was with the footswitch back in was a slight ticking inside the chassis when on ch 2.
Set up again at home tonight for another look. Again nothing can't get the ticking sound now. I changed every pre amp valve 1 at a time then switched all the power valves for a new set. Nothing!!
Anyone got any suggestions?
Thanks
 
If you're sure you got good preamp tubes in at replacement...then move on to the power tubes. Probably should get it to an amp tech.
 
Hi. Thanks for reply. Yeah I replaced all the pre and power tubes. I’ve sent the amp back under warranty. I’ll let you all know the outcome.
It’s killing me not having my Lonestar
 
Well that's weird!! After the amp not working which was witnessed by me, my supplier and the distributor rep. It now is!! It was taken back to the distributor under warranty. The tech apparently took it out the chassis and plugged it in and it worked fine. It has supposedly been checked over with no fault found. It was put back in the housing and played for an hour with no problem.
So I've got it back and it sounds great however I've lost a bit of confidence in the amp. I was wanting the problem identified and sorted. Can't help thinking what will stop that happening again.
 
I hear you - it is the same feeling I had years ago with my Acoustic G 100 T that broke down after a gig triggering a 200$ repair bill - mucho dinero for a student, and I could not work on amps myself at that time. The only thing to regain confidence in the amp is to play the amp. If it works, it works. The only other thing that comes to mind is to check every connection before firing up the amp, especially if there is a speaker plugged in.

Cheers Stephan
 
Back
Top