The Boogie Board

Discussion Forum for Mesa Boogie Products
It is currently Fri Oct 20, 2017 1:59 am

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: DC-2 footswitch jack
PostPosted: Sat Dec 24, 2016 10:17 pm 
Offline
Bottle Rocket

Joined: Wed Jan 27, 2016 11:27 am
Posts: 2
I just picked up a DC-2. I've had a couple of Mesa's before, 50 cal, and express 5:50 and and a Triaxis (still have it, collecting dust). This seems like a great little amp for what I'll use it for. It came with, what I assume is.., the original footswitch, just the lead/clean channel switch.
1. Is the front panel foot switch jack TRS with the tip the channel and the ring the reverb and the rear is the other way around? or are they both TS, front for channel and rear for reverb. (I checked the manual and like a lot of Mesa's documentation, it was colorfully written, but not very helpful)

2. Is there a footswitch available for this (both channel and verb) or do I need to make one?

Thanks!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group