Urgent help needed with a Mesa Boogie DC-3......Can anybody please tell me where this signal path leads?
With the front control panel facing you it's the right LDR.... the right leg of the photo resistor side of the LDR. On the top side of the board there is a signal path that leads to the 1mohm resistor (as also shown on the schematic) but where the underside of the board shows another signal path that disappears underneath the V1 tube socket. Can anyone do a continuity test and tell me where it leads?
Here's the photo of the signal path I'm talking about, the solder point is pointed out with a red arrow:
http://www.flickr.com/photos/73835524@N00/3409897384/sizes/l/
thanks
With the front control panel facing you it's the right LDR.... the right leg of the photo resistor side of the LDR. On the top side of the board there is a signal path that leads to the 1mohm resistor (as also shown on the schematic) but where the underside of the board shows another signal path that disappears underneath the V1 tube socket. Can anyone do a continuity test and tell me where it leads?
Here's the photo of the signal path I'm talking about, the solder point is pointed out with a red arrow:
http://www.flickr.com/photos/73835524@N00/3409897384/sizes/l/
thanks
