So I haven’t powered my Solo 50 Single Rectifier up in about 4 years. I decided to fire it up and jam a little. From past experience I know you have to let the tubes warm up so I waited like 5 minutes and I flipped the Standby switch and I could hear it really low. So I turned the volume up a little and I could hear it a little better but still sounding like I have a problem.
I flipped it back to Standby off, waited a few more minutes, came back and flipped the Standby on again and saw a flash like inside the amp and boom ...it’s completely dead.
Think I just need a tube job? Worst case scenario?
Is it even worth throwing money at? (I don’t know how to do this stuff myself.)
I flipped it back to Standby off, waited a few more minutes, came back and flipped the Standby on again and saw a flash like inside the amp and boom ...it’s completely dead.
Think I just need a tube job? Worst case scenario?
Is it even worth throwing money at? (I don’t know how to do this stuff myself.)