The Boogie Board

Hi,

I have an old - not sure how old, but old, 2x12 horizontal wedge cab. It sits like a monitor wedge. It has two black shadows in it, and two high range controls that have been disabled. The cab is pretty beat up, but sounds fantastic. I would really like to replace the grill (big tear) and tolex. However, for the life of me, I cannot figure out how to get the grill off. I can't see any screws through the grill. I took the access panel off, there are none in the speaker board. Is it glued on? I sure hope not! Anyone have any ideas?

I have ben trying to get in touch with Mesa but their site is down. Anyone have the email address for support? Thanks. I don't want to call them with such a low level question. I know how busy they are.

Joe

_________________
Mark V Combo
Roadster 2x12 Combo
Bad Cat Hot Cat 30R Head and Cab
2006 Suhr Standard Braz FB
88 Dot 335 Reissue Blond Holmes PUPS
Music Man Petruccii BFR w Piezo
2 PRS Cu24's 10 Birds
2005 Les Paul Class 5 WCRs
AxeFX II MFC
Matrix GT1000FX

I have the same problem. I have a 1x12 wedge monitor and I cannot figure out how to get the grille off.
Maybe Authorized Boogie can help explain?

Thank you!

_________________
Daniel

I have a 1x12 wedge monitor and I want to replace the speaker.

If I remove the back panel, the opening is too small for the speaker to come out thorough it.

I need to get the grille off but I cannot figure out how.
Maybe Authorized Boogie can explain how to do it?

Thanks in advance.

_________________
Daniel

maybe it is attached with some of that industrial strength velcro type stuff?

_________________
When Gibsons are outlawed, only outlaws will have Gibsons

You are totally right. That was the case. Thank you for the advice!!

_________________
Daniel