Removed a couple tubes, now problems....

Talk about tubes and their effect on your tone

Moderators: Guitarzan, Grandor, ned

Post Reply
OzBoog
Bottle Rocket
Posts: 1
Joined: Tue Apr 26, 2011 5:33 am

Removed a couple tubes, now problems....

Post by OzBoog » Tue Apr 26, 2011 5:40 am

Hey everyone.
I just took two power tubes out of my 3 chan dual rec because 100 watts is way too loud.
50 watts sounds far more to my liking.
I took the middle two out, leaving the outer two.
Played through the amp for a while and all was fine.
Switched the amp to standby and went off and did some things, when I came back later the amp had shut off.
Tried turning the power switch off then back on, nothing.
Rectifier switch is set to "Normal".
Power switch is set to "Bold".
Have I done something idiotic here for this to be happening?
Cheers.

**Quick update. I unplugged power cable from the head and took the fuse out and screwed it back in, and the amp started working again when I powered it back up.
It just shut off again though now for no reason. Anyone have any ideas?

**Update part 2. I've been reading the Mesa Manual (Who would have thunk it?) and it says if you are going to remove two tubes to cut power by 50% you also need to remove one Rectifier tube to compensate. I'll try this. It's probably overloading.

zodiac272
Donating Member
Posts: 1048
Joined: Fri May 14, 2010 2:00 am
Location: Chicago
Contact:

Re: Removed a couple tubes, now problems....

Post by zodiac272 » Tue Apr 26, 2011 10:47 pm

maybe also switch to the solid state rectifier to see if you get good tone, and maybe you can eliminate the rec. tubes, see if they have an issue


scott
Mark IIC+ KDG "Road Head"
Mark IIC+ HRG
Mesa 2:90
Digitech GSP2101
ESP JH-2 Explorer
LTD Explorer
Ibanez S-540
Boogie 1x12 Thiele, 1x12 Compact Cab
Boogie 4x12 Cream Halfback

User avatar
crane
Mark III
Posts: 482
Joined: Fri May 09, 2008 4:22 am

Re: Removed a couple tubes, now problems....

Post by crane » Wed Apr 27, 2011 12:48 pm

You should also plug your cabinet to an output half from his value. If your cab is 8 ohms, plug it to the 4 ohm output. As the output tranny's primary "see" a doubled load because you remove two tubes (works in //, so half tubes means double load), the tranny's secondary must "see" a doubled charge too.
PRS McCarty Soapbar with BKP Pigs90, PRS custom 22 with BKP Rebel Yell
Mark V Head, 1x12" Mesa 1/2 closed (EVM-12L)
Triaxis 2.0 noFat - Quad preamp
Deep modded 20:20 - Bias modded 50/50 - SimulClass 295
Home made amps/speakers/pedals

Post Reply