Search results

The Boogie Board

Help Support The Boogie Board:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. P

    Maverick Mod: Rhythm channel Blackfaced (Lone Star-ed?)

    I replaced the relay i got a couple of mesa but it made no difference all voltages are more or less ok according to the schematic its had new dmr and filter caps just annoying when it happens thanks anyway.
  2. P

    Maverick Mod: Rhythm channel Blackfaced (Lone Star-ed?)

    Hi steeve interesting reading I would be interested in seeing what you have drawn up to maybe try some on my Maverick. I'm still having a problem ith the lead channel on mine when I first switch on from cold after about a Minute Relay 3 (channel switching) Starts chattering like crazy it lasts...
  3. P

    My Maverick sounds flat and dull

    Ok replaced filter caps and clean channel ok however on lead channel whenever I play or just touch the jack tip relay 3 s chattering and buzzing it' nuts off but the sound is there. I have checked voltages from the schematic and they are ok all resistors check out ok around the relay to and...
  4. P

    My Maverick sounds flat and dull

    Thanks for the replies Iv'e only checked the output valves which are fairly new. I did a full re-valve less than 12 months from Watford valves here in the UK. I did hard wire the plastic connectors a while a go after it was giving intermitent noise due to a bad joint it has been perfect since...
  5. P

    My Maverick sounds flat and dull

    Hi my 1 X 12 Maverick seems to have lost it's mesa tone it just sounds dull and lifeless iv'e subbed tubes and tweeked away but it just lacks what it normally has great tone. Any ideas? what I could start to check to try and sort it please. Thanks
  6. P

    1 X 12 Maverick Hum (again)

    Thanks Monsta-Tone yeah here are the pics of the connector easy to see the hot spot. By the way it also cured some relay chatter at switch on. Yes I think you are right maybe a weak spot, I think if it re occurs I will just solder them direct thanks for the reply
  7. P

    1 X 12 Maverick Hum (again)

    Anyone help on the speakers ? please
  8. P

    1 X 12 Maverick Hum (again)

    Thanks for the quick replies it turned out to be the connector going to the board the big one thats split into a 3 pin and 7 pin I think, the wires are sort of crimped into it one was a little brown with heat on closer look it was not making a good contact, I think its on the ground loop so...
  9. P

    1 X 12 Maverick Hum (again)

    Hi I have a lovely 1 X 12 Maverick Combo that was all sorted and running well but just lately there is a hum just on the clean channel on both valve and solid state rectifier settings all valves are good (tested by subbing them with known good ones). Lead channel is fine no hum at all its just...
  10. P

    Maverick Hum

    Thanks 94Tremoverb ill take a look at the things you suggested later on this week and post the results thanks again :D Plucker
  11. P

    Maverick Hum

    I have a Maverick 1X12 and its has an annoying hum that comes and goes. Even with the Master and Volumes down and the reverb right down in fact all controls up or down I get this Hum that comes in cycles for a few seconds then dies away It's not affected by the volumes its just there if anyone...
  12. P

    Maverick problems

    I think Relay 2 switches the lead / rhythm reverb signal I would check the voltage there first but the LDR's are worth checking as they are used to switch channels, among other things and from what im told lose 10% of there tolerence every year...
  13. P

    Maverick problems

    Just in case anyone is inteseted all the LDR'S are supposed to be VTL5C2 there was a real odd on in there and a couple of 9's obviously been done before with the wrong parts. After replacing them with new ones and a revalve it seems to be working fine again....
  14. P

    Maverick problems

    Also is it possible to get hold of circuit diagrams or board layouts anywhere as the schematic is quite limited and hard to follow ? Thanks
  15. P

    [USEFUL] recording tips..tone..mike placement..etc VIDEO

    Thanks that's really useful
  16. P

    Lightning strikes!

    Sometimes it can take out a grid resistor (if your unlucky) it might be worth taking a look to see if any are burnt or cracked before you replace the tube & fuse.
  17. P

    Thiele Re-Tolex project - Just finsihed it, take a look.

    Thats a really nice job :D I have recovered a few cabs and use Evo-Stik timebond contact adhesive for the tolex as it gives you a bit of time to move things around and get any bubbles out. It goes off in about 2 hours.
  18. P

    Maverick problems

    Hi I have a Maverick 1X12 that has a couple of problems Does anyone know the part no's of LDR 2 & 4, I know 1 & 3 are VTL5C9 but can't see the others as they are mounted with the part no's against the board. I want to replace them as I get some bleed from the lead channel into the clean...
Back
Top