Search results

:)

Correct. It's only active in parallel.

You're welcome. So it's working now?

Hi, In your photos: 1. The pre-existing red wire that is attached to the top terminal of the potentiometer, must be detached and connected to the middle-right terminal of your switch. 2. The top-right terminal of your switch must be connected via a new red wire to the top terminal of your...

I use a GT-8 (in manual mode) via the 4-cable-method, and the signal gets a bit squashed in the loop portion. Usually it doesn't bother me, but sometimes it does. It's kind of convenient to just flip a switch on the back of the amp, with the mix knob already dialed in, and then just switch to...

Since you are retolexing, you could fill the holes, redrill them the diameter of the bolts, tolex the amp, and use the same chrome bars as the Express uses. I'm assuming the spacing is the same on both amps, you might want to verify that.

Hello fellow DC-5 modders, I came up with a simple design for switching between a series or parallel FX loop. I've gathered insight from this forum in the past and thought I should reciprocate. My design: Wiring: Drilled hole: Finished Project: I oriented the toggle switch so that...